Historic Shooting Forums › General › Reloading › Bullets and moulds v
.45-70 mould recommendation?

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
.45-70 mould recommendation?
02-20-2018, 11:33 PM,
#2
Don McDowell Offline
Administrator
*******
 		Posts: 6,735
Location: Ft. Laramie Wy
Joined: May 2012
Reputation: 2
RE: .45-70 mould recommendation?
The saeco 645 cast from 20-1 is a good bullet in the 45-70. Both the .458 diameter 525 gr and 535 gr money bullets cast from 16-1 are good in the 45-70. Last but certainly not least is the Lyman 457132 cast from 20-1. I also like the Rcbs 82084 bullet cast from 20-1, but it's not particularly good past 800 yards due to it only having 3 lube grooves I think those cause to much drag on the bullet when going past 800.
A wise man can always be found alone. A weak man can always be found in a crowd.
Find
Reply


Messages In This Thread
.45-70 mould recommendation? - by Hanz - 02-20-2018, 11:25 PM
RE: .45-70 mould recommendation? - by Don McDowell - 02-20-2018, 11:33 PM
RE: .45-70 mould recommendation? - by rdnck - 02-21-2018, 08:27 AM
RE: .45-70 mould recommendation? - by Hanz - 02-21-2018, 08:43 AM
RE: .45-70 mould recommendation? - by SgtDog0311 - 02-23-2018, 07:55 AM
RE: .45-70 mould recommendation? - by Hanz - 02-23-2018, 08:18 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication