Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Round target observation..
10-11-2013, 12:40 PM,
#1
Round target observation..
Got to thinking about this in the Vortex scope discussion on the Shiloh board.
Over the course of time one thing I've come to notice is how many folks mistake a low hit ( miss on a steel target) at say 5 or 7 oclock as a need to make a big windage adjustment.Have seen many make the same mistake on diamond shaped gongs as well. But what it actually requires first is an elevation adjustment, then see if /how much wind is needed to get into the x ring. Often times a couple minutes elevation will be a ten ring, then touch the wind to the x ring.
Also folks over estimate in their minds how many minutes from one score ring to the next. Often times forgetting that just the bullet diameter of a 45, will occupy 1/2 minute at 100 yds, and a 1/4 at 2.
A little goes a long way, when making sight adjusts.
Reply
10-11-2013, 02:37 PM,
#2
RE: Round target observation..
Don I agree,

yet have also seen folks make a clean miss off the side of a Creedmoor target say at 3 and give only a min of left? when it takes 4 MOA to reach center. A correct elevation is a must.

Kenny W
Reply
10-11-2013, 10:20 PM,
#3
RE: Round target observation..
Yes, I wonder sometimes what folks are thinking..
Reply
10-11-2013, 11:41 PM,
#4
RE: Round target observation..
And don't forget the difference a two minute horozontal or vertical load will do also
The reason a dog has so many friends is because he wags his tail instead of his tongue.
Reply
10-11-2013, 11:50 PM,
#5
RE: Round target observation..
Good point Kurt, I watched folks chasing individual shots and wondered if they had figured group size before cranking on the dials..
Reply
10-11-2013, 11:58 PM,
#6
RE: Round target observation..
Kurt you make a huge valid point.

The other: a proper Mech Zero and No Wind zero. Most folks that come to my match dont have a frigging clue to that and are already way behind the ball on that.

Kenny W
Reply
10-12-2013, 12:15 AM,
#7
RE: Round target observation..
I felt real bad when Butch's front sight fell out during the prep period on the last day at 900, with those screwball conditions throwing brakelights up and down the target pits, and then to not have a clue as to where true zero might be? Lordy, but he came back and did pretty well, but we barely had enough time to get the sighters and score shots in.
Reply
10-12-2013, 12:43 AM,
#8
RE: Round target observation..
HMMMMMM I seem to remember someone elses front sight falling off once Smile
The reason a dog has so many friends is because he wags his tail instead of his tongue.
Reply
10-12-2013, 02:19 PM,
#9
RE: Round target observation..
Blush Yup really sucks when that happensConfused Almost as bad as when the conditions will make a full minute elevation change jump off the target, and you go to make a touch adjustment, loosen the eye cup and the slide drops 10 points.AngryAngry Good thing nobody tried to tell me what a good sight that is supposed to be for about 30 minutes until I got myself cool and collected.AngryUndecided
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication