Hey LynC2

[LynC2]

lynnc2,
I am currently experimenting with a 2 diameter pp mould in 40 cal.
the main part of the bullet patches to bore, and the base part patches to 0.406, just under groove, allowing finger seating in fired cases.
the base is 0.125 in the case, and about 0.010 out to contact the 7 degree transition angle.
this mould was made by kal, and is an excellent long range bullet with its elliptical nose.
it has only had 1 outing at 990 yds where it held good vert, but it has also shot 660, 770, and 880 yds with excellent vert.
keep safe,
bruce.

That sounds like it is shooting well for you. Do think there is any advantage with the 2 diameter bullet over a bore diameter PP?
Lyn