Accurate Molds

[Ironramrod]

Guys, I'm considering a double cavity mold from Accurate molds; 1 bullet cavity in the 45-400T pp design and the other bullet cavity in 45-500T pp design. Both designs to be shot in a Shiloh .45/70 and the larger design to be shot in a Shiloh .45/110. The objective for both is hunting bullets w/ a little more velocity, and for use at mid-range target distances. I'm kinda leaning toward either an aluminum or iron mold.

I'd like you guys opinions, experience w/ bullets of this type; good, bad, or ugly. Thanks

Regards