Just another mould..or two.

[J.B.]

I'm sure it will be fine. I'm pretty much using Seth Cole ...55w or yellow as they are the two thinnest I've been able to find in any volume. The yellow definitely finer and between the two usually have the latitude to thicken or thin the base when wrapped to friction fit in the fired cases. I've been keen to try the Lee push through sizing dies that Jim and a few of you guys have used to true up the diameter for a given case. Actually I went on line to order some more for both the 40 and the 50 but while Lee shows them, they currently arent shipping to Australia ( and a few other countries also ) due to problems with the USPS apparently being stretched a bit thin with resources. I had the same problem when I ordered the mould but Gayle was able to get around it by sending it priority. Cost me another $20 but over the price of the mould it was a non issue. Priority international for an order with Lee of probably only $40 or so...isnt quite so enticing. There will be no shooting here until late January now at the earliest....and they are starting to 'wind everyone up again' with this supposed 'new strain' business. I dearly hope it doesnt impact travel again. This world has to start spinning again or it will never get off its feet. Keep the momentum going as it were.
Gavin.