Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Designing the 2-diameter paper patch bullet.
01-04-2019, 12:23 AM,
#92
RE: Designing the 2-diameter paper patch bullet.
Gavin,

You are correct about the twist vs. length thing. I had a .44-100 Remington in an 18-twist and that's a bit slow for a .44 caliber much over 485 grains and it preferred fairly blunt bullets even then. It did well out to 600 yards with my 485 grain bullet, I don't recall the length, but nothing worked well past 800.
Jim Kluskens
aka Distant Thunder
Reply


Messages In This Thread
RE: Designing the 2-diameter paper patch bullet. - by Distant Thunder - 01-04-2019, 12:23 AM
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 01-04-2019, 04:29 PM
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 05-06-2019, 09:48 AM
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 05-06-2019, 10:25 AM
RE: Designing the 2-diameter paper patch bullet. - by Steveu - 01-16-2024, 12:10 PM

Forum Jump:


Users browsing this thread: 11 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication