Historic Shooting Forums › General › Reloading › Paper Patch v
Designing the 2-diameter paper patch bullet.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Designing the 2-diameter paper patch bullet.
11-07-2018, 06:22 PM, (This post was last modified: 11-07-2018, 06:24 PM by Distant Thunder.)
#53
Distant Thunder Offline
Posting Freak
*****
 		Posts: 921
Location: NE Wiscinsin
Joined: May 2017
Reputation: 0
RE: Designing the 2-diameter paper patch bullet.
(11-07-2018, 09:33 AM)Don McDowell Wrote: Arnie on another forum says his 40 bullets weight 360 and 371 grains.

Yes at the length for his 16-twist he is right about there but if I were to shorten that design to 1.240" or 1.250" for my 18-twist I don't think it would even get up to 350 grains, certainly not any more than that. I forget what length Arnie's bullet is but it would be too long for my 18.
Jim Kluskens
aka Distant Thunder
Find
Reply


Messages In This Thread
RE: Designing the 2-diameter paper patch bullet. - by Distant Thunder - 11-07-2018, 06:22 PM
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 01-04-2019, 04:29 PM
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 05-06-2019, 09:48 AM
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 05-06-2019, 10:25 AM
RE: Designing the 2-diameter paper patch bullet. - by Steveu - 01-16-2024, 12:10 PM

Forum Jump:


Users browsing this thread: 5 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication