Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
44-77 Dies
03-18-2018, 11:10 PM,
#7
RE: 44-77 Dies
I made up my own bushing die. It took some thinking and some scratching but I have one die that I neck size, de-prime, flair, compress if needed and seat the bullet. I have a separate bushing I made up to take the flair off the case mouth and put a slight taper crimp on the mouth. I made it so that it would hold an RCBS de caping stem. if anyone wants I can post it as a PDF and your can print it out and make changes as needed to fit your needs. Before I would post the print I would like to check the parts against the prints as things may have changed a bit. I think the original design was for the 45-70 and the die may have been opened up a bit on the inside to fit the 44 case.
Sam
Reply


Messages In This Thread
44-77 Dies - by John - 03-18-2018, 12:24 PM
RE: 44-77 Dies - by Eric Johanen - 03-18-2018, 05:29 PM
RE: 44-77 Dies - by John - 03-18-2018, 06:32 PM
RE: 44-77 Dies - by Kurt - 03-18-2018, 06:50 PM
RE: 44-77 Dies - by John - 03-18-2018, 07:22 PM
RE: 44-77 Dies - by Kurt - 03-18-2018, 10:16 PM
RE: 44-77 Dies - by Nuclearcricket - 03-18-2018, 11:10 PM
RE: 44-77 Dies - by Kurt - 03-18-2018, 11:45 PM
RE: 44-77 Dies - by Nuclearcricket - 03-19-2018, 10:17 AM
RE: 44-77 Dies - by Kurt - 03-19-2018, 11:18 AM
RE: 44-77 Dies - by Don McDowell - 03-19-2018, 09:59 PM
RE: 44-77 Dies - by J.B. - 03-20-2018, 10:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication