New P.P mold for 45-70

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Thread Modes

New P.P mold for 45-70

12-19-2017, 04:38 PM,

#12

bruce moulds
Guest

RE: New P.P mold for 45-70

further thought.
if deep seating the bullet so that 65 gn powder is used then 1.4" might be better.
if using a full case of powder (80 + gns), 1.450 would be o.k.
keep safe,
bruce.

« Next Oldest | Next Newest »

Messages In This Thread

New P.P mold for 45-70 - by Randy Bohannon - 12-18-2017, 12:00 PM

RE: New P.P mold for 45-70 - by Mike - 12-18-2017, 02:29 PM

RE: New P.P mold for 45-70 - by mherth - 12-18-2017, 04:14 PM

RE: New P.P mold for 45-70 - by Don McDowell - 12-18-2017, 04:24 PM

RE: New P.P mold for 45-70 - by bruce moulds - 12-18-2017, 04:25 PM

RE: New P.P mold for 45-70 - by Randy Bohannon - 12-18-2017, 05:51 PM

RE: New P.P mold for 45-70 - by bruce moulds - 12-18-2017, 09:04 PM

RE: New P.P mold for 45-70 - by Randy Bohannon - 12-19-2017, 11:07 AM

RE: New P.P mold for 45-70 - by Kurt - 12-19-2017, 11:25 AM

RE: New P.P mold for 45-70 - by Randy Bohannon - 12-19-2017, 02:38 PM

RE: New P.P mold for 45-70 - by bruce moulds - 12-19-2017, 04:05 PM

RE: New P.P mold for 45-70 - by bruce moulds - 12-19-2017, 04:38 PM

RE: New P.P mold for 45-70 - by Distant Thunder - 12-20-2017, 10:54 PM

RE: New P.P mold for 45-70 - by Randy Bohannon - 12-21-2017, 06:03 PM

RE: New P.P mold for 45-70 - by Distant Thunder - 12-21-2017, 07:03 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me