Mixing Alloy

Thread Rating:

Thread Modes

Mixing Alloy

07-01-2016, 10:36 AM, (This post was last modified: 07-01-2016, 10:41 AM by Old Jim.)

Old Jim Offline

Kindly old gent

Posts: 768
Location: Central USA
Joined: May 2012
Reputation: 1

RE: Mixing Alloy

Don, that 1# tin/20# of shot just may a bit to hard, but a test will tell. Do you have a hardness tester?

Good buy on the shot though!

That's my story, and I'm stickin' to it!

Find

« Next Oldest | Next Newest »

Messages In This Thread

Mixing Alloy - by Don McDowell - 06-30-2016, 11:04 PM

RE: Mixing Alloy - by parkergunz - 07-01-2016, 01:29 AM

RE: Mixing Alloy - by Don McDowell - 07-01-2016, 08:51 AM

RE: Mixing Alloy - by Old Jim - 07-01-2016, 10:36 AM

RE: Mixing Alloy - by Don McDowell - 07-01-2016, 11:49 AM

RE: Mixing Alloy - by Old Jim - 07-01-2016, 12:44 PM

RE: Mixing Alloy - by Hiwall55 - 07-01-2016, 01:28 PM

RE: Mixing Alloy - by Don McDowell - 07-01-2016, 01:30 PM

RE: Mixing Alloy - by Lumpy Grits - 07-01-2016, 10:31 PM

RE: Mixing Alloy - by Don McDowell - 07-01-2016, 11:30 PM

RE: Mixing Alloy - by Lumpy Grits - 07-02-2016, 02:13 AM

RE: Mixing Alloy - by Ironramrod - 08-30-2016, 07:48 PM

RE: Mixing Alloy - by Don McDowell - 08-30-2016, 08:37 PM

Users browsing this thread: 11 Guest(s)