Historic Shooting Forums › General › Reloading › Bullets and moulds v
PP mould for .45/70

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
PP mould for .45/70
12-06-2014, 05:34 PM,
#5
Kurt Offline
Grand advisory committee
*****
 		Posts: 4,246
Location:
Joined: May 2012
Reputation: 2
RE: PP mould for .45/70
I don't know what your intentions are, patching to groove or bore diameter.
I would ask if your planning on patching to bore before you order the mould. Form what I see o the mould specs that they are .45 if that is what he is cutting that mould at you will be patching it to groove diameter.
Unless I don't understand his drawings.

Kurt
The reason a dog has so many friends is because he wags his tail instead of his tongue.
Find
Reply


Messages In This Thread
PP mould for .45/70 - by Ironramrod - 12-05-2014, 01:46 PM
RE: PP mould for .45/70 - by Kurt - 12-05-2014, 05:39 PM
RE: PP mould for .45/70 - by Don McDowell - 12-05-2014, 09:09 PM
RE: PP mould for .45/70 - by Ironramrod - 12-06-2014, 12:56 PM
RE: PP mould for .45/70 - by Kurt - 12-06-2014, 05:34 PM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 12:10 AM
RE: PP mould for .45/70 - by powderburner - 12-07-2014, 12:26 AM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 10:58 AM
RE: PP mould for .45/70 - by Don McDowell - 12-07-2014, 11:30 AM
RE: PP mould for .45/70 - by Kurt - 12-07-2014, 12:39 PM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 01:45 PM
RE: PP mould for .45/70 - by Don McDowell - 12-07-2014, 02:05 PM
RE: PP mould for .45/70 - by powderburner - 12-07-2014, 02:39 PM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 03:44 PM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 06:15 PM
RE: PP mould for .45/70 - by Ironramrod - 12-08-2014, 12:16 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication