Historic Shooting Forums › General › Reloading › Bullets and moulds v
Before adding ...

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Before adding ...
05-18-2014, 09:16 AM,
#6
Old Jim Offline
Kindly old gent
*****
 		Posts: 768
Location: Central USA
Joined: May 2012
Reputation: 1
RE: Before adding ...
I found what Kurt said about turnin' down the heat. I dropped from 780 to 730 for the 16:1 alloy ... not a lot, but some. Also no measurable differences in the cast bullets, save the wt. The bullet used in the trial was a .458 x 532 gr. Boomer Money bullet. His moulds are some of the largest blocks around.

Ya know something? That Kurt guy is a smart fellow!!!!!!!!!!!!!!!!
That's my story, and I'm stickin' to it!
Find
Reply


Messages In This Thread
Before adding ... - by Old Jim - 05-13-2014, 04:47 PM
RE: Before adding ... - by powderburner - 05-13-2014, 06:09 PM
RE: Before adding ... - by Don McDowell - 05-13-2014, 07:50 PM
RE: Before adding ... - by craneman - 05-14-2014, 09:54 AM
RE: Before adding ... - by Kurt - 05-16-2014, 05:41 PM
RE: Before adding ... - by Old Jim - 05-18-2014, 09:16 AM
RE: Before adding ... - by Don McDowell - 05-18-2014, 09:31 AM
RE: Before adding ... - by Kurt - 05-18-2014, 09:52 AM
RE: Before adding ... - by Iron Coyote - 05-18-2014, 10:16 AM
RE: Before adding ... - by craneman - 05-18-2014, 12:05 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication