Slug Guns and Muzzleloaders

[Kenny Wasserburger]

I run a wet patch down to the powder chamber area let it soak for about 10-12 seconds. Pull my sealed igniton and put it in jar to soak. Then up and out and Toss, run a second wet patch down and up and the other side same. Then I switch rods to one with a Breach face scraper run it down to the breach plug and give it a few turns up it comes with a lot of junk on the scraper. 1 dry patch down both sides. Next powder in the drop tube down to chamber area. No wad used in my load using 1-60 Alloy bullet and cross patches lube with Nye Oil. Bullet seated down powder with about 5 to 6# of pressure index finger on end of rod till painful 10 seconds.

I pick the Nipple with a wire made for such, use a scrapper to clean off nipple area also. Clean sealed ignition and reprime, set rifle on bench and install sealed igniton. Fire on the command.


KW