Getting Back into It

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Thread Modes

Getting Back into It

09-27-2013, 10:52 AM,

#15

Flash Pan Dan
Guest

RE: Getting Back into It

Well, I tried the nylon brush with wet patch and that relieved the fouling issue but then I found that I had run out of the 2F powder I have been using so I gave it a try with what powder I have left; KIK 3F. Using the KIK powder I had no fouling issues at all. A single wet patch followed by a dry patch left the bore ready for the next shot. But I will have to do a little more load development with this switch.

The 3F is denser and it doesn’t fill the case quite like the 2F. Anyone ever use 3F? Any words of wisdom and experience would be greatly appreciated.

« Next Oldest | Next Newest »

Messages In This Thread

Getting Back into It - by Flash Pan Dan - 08-28-2013, 05:11 PM

RE: Getting Back into It - by bobw - 08-28-2013, 08:32 PM

RE: Getting Back into It - by Kurt - 08-28-2013, 08:41 PM

RE: Getting Back into It - by Flash Pan Dan - 08-28-2013, 11:20 PM

RE: Getting Back into It - by rdnck - 08-29-2013, 11:25 AM

RE: Getting Back into It - by Flash Pan Dan - 09-04-2013, 08:48 PM

RE: Getting Back into It - by Ironramrod - 09-05-2013, 09:13 AM

RE: Getting Back into It - by Flash Pan Dan - 09-27-2013, 10:52 AM

RE: Getting Back into It - by Flash Pan Dan - 09-09-2013, 06:40 PM

RE: Getting Back into It - by Ironramrod - 09-11-2013, 03:19 PM

RE: Getting Back into It - by Kurt - 09-11-2013, 04:01 PM

RE: Getting Back into It - by Flash Pan Dan - 09-17-2013, 03:35 PM

RE: Getting Back into It - by bruce moulds - 09-17-2013, 05:00 PM

RE: Getting Back into It - by Flash Pan Dan - 09-17-2013, 05:31 PM

RE: Getting Back into It - by bruce moulds - 09-17-2013, 09:50 PM

RE: Getting Back into It - by Flash Pan Dan - 10-04-2013, 05:54 PM

RE: Getting Back into It - by Don McDowell - 10-04-2013, 06:10 PM

RE: Getting Back into It - by Dave Roelle - 10-04-2013, 08:10 PM

RE: Getting Back into It - by Flash Pan Dan - 10-09-2013, 03:42 PM

RE: Getting Back into It - by Ironramrod - 10-09-2013, 05:43 PM

RE: Getting Back into It - by Flash Pan Dan - 10-11-2013, 11:29 AM

RE: Getting Back into It - by Robert L - 10-12-2013, 08:34 PM

RE: Getting Back into It - by Ironramrod - 10-12-2013, 10:09 PM

RE: Getting Back into It - by Flash Pan Dan - 10-15-2013, 11:15 AM

RE: Getting Back into It - by Flash Pan Dan - 10-23-2013, 06:28 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me