rear sight glare

[chaneylake]

CL
From your description seeing a glare on the bottom 50% sounds to me like you have the tang tipped back to fat and your lust looking through part of the aperture.
Tip tour staff forward a little and see if that "glare" goes away. If it does reset the spring under the tang when you get it where you heed to have it.
When you shoot long range you might have to adjust the staff forward a little to get a full hole and move it back when shooting close.

Kurt

I will address what you stated tomorrow, today I also noticed that as I was changing aperture size on the rear sight it would get real clear just before it clicked into position, is this also a sign of a "fat tang" ???????

Sure sounds like it to me.
Level your rifle front to back via the bbl.
The back of your tang sight should be 90* to the perpendicular of the leveled bbl.
A machinist bubble-level will do this...
Gary

ok, I understand what everyone is stating, is the screw slot in the spring slotted, how do I adjust the plumb of the tang if that is the problem