Paper Question

[J.B.]

Kurt, while touching on the Lee 'push through' sizer dies I wondered if you used any lube on the paper or doing just fine pushing them through dry ? I've ordered a couple and used them mainly for the 40 calibre projectiles. They certainly work but find it will actually cut the paper at the fold under the bullet quite often. Whether this is my wrapping ( always quite likely ) or just another technique I need to get a handle on. ? I try to set my moulds up around S.C. 55 W but every now and then the necks are just a tad too tight..so a run through the die or dropping back to S.C. yellow. Most of the other papers I've been able to source are significantly more thick..as per Arnies table ( thanks Arnie ) . A shame because some of slightly thicker papers seem to wrap more evenly..or they do for me at any rate.
rgds.. gavin.