Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
44-77 continuing development
06-04-2021, 10:08 AM, (This post was last modified: 06-04-2021, 10:15 AM by Kurt.)
#7
RE: 44-77 continuing development
I don't know guys about the thin paper. I have several rolls of yellow when Staples closed their doors and the price was 3.95 a roll I got 6 yellow and white. That paper runs .0013 to .0016 depending where you put the mic checking it. I have some bullets that are a little large like .436 for the .44 and .335" for the .40 and I normally use paper that is .0018" to .002" thick and I have to run them through the sizing die so they chamber and the results are good doing this, but if I use the yellow paper I get very fine lead slivers when cleaning and pushing a clean dry patch through it is covered with fine gray streaks telling me that there is still some lead smears in the bore.
Granted, I seldom shoot less than 30 rounds when I head to the range, usually I shoot more than 50-60 rounds but I wipe between shots. I know Don that you have said that you don't get lead using the 7# but I sure do and I know that my patches are ahead of the land cuts on the fired bullets but I still get lead in the bore and at the end of the range session and I see the shots spreading out farther on the target.

I use paper that wrapped is thicker than the groove is deep and there are no lead smears on the final cleaning patch.
The reason a dog has so many friends is because he wags his tail instead of his tongue.
Reply


Messages In This Thread
44-77 continuing development - by Distant Thunder - 06-03-2021, 05:05 PM
RE: 44-77 continuing development - by Kurt - 06-04-2021, 10:08 AM
RE: 44-77 continuing development - by Kurt - 06-04-2021, 06:19 PM
RE: 44-77 continuing development - by Kurt - 06-07-2021, 02:49 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication