Historic Shooting Forums › General › Reloading › Paper Patch v
Development of PP loads for the .44-77.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Development of PP loads for the .44-77.
07-31-2020, 07:55 PM, (This post was last modified: 07-31-2020, 08:17 PM by Distant Thunder.)
#235
Distant Thunder Offline
Posting Freak
*****
 		Posts: 921
Location: NE Wiscinsin
Joined: May 2017
Reputation: 0
RE: Development of PP loads for the .44-77.
Don't hit the house! That would be bad.

I'm going to try a wad stack tomorrow with 86 grain load. I shot one like that today as a fouler and I just have a feeling that with a bit more compression the 86 grain might improve, but it's just a feeling.

Turning the necks on the BACO cases was really easy once I got set up. Now I'll do the rest of the cases, it sure didn't hurt the accuracy any. That will make the BACO cases very usable with this 2-D bullet and the capacity is very close if not exactly the same as the JBA cases.

Kurt, if you have a .44-77 with a standard Shiloh chamber you should try that bullet in it. That is the chamber it was designed for.
Jim Kluskens
aka Distant Thunder
Find
Reply


Messages In This Thread
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 09:24 AM
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 05:59 PM
RE: Development of PP loads for the .44-77. - by seahawk - 07-01-2020, 10:08 AM
RE: Development of PP loads for the .44-77. - by Steveu - 07-31-2020, 11:16 AM
RE: Development of PP loads for the .44-77. - by Distant Thunder - 07-31-2020, 07:55 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication