Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Development of PP loads for the .44-77.
07-30-2020, 11:35 PM,
RE: Development of PP loads for the .44-77.
I load 5 each with 86, 87 and 88 grains of 1 1/2 Swiss. I will shoot those tomorrow morning. I just need to figure out a better target setup. The 6 inch paper plates are nice but when trying different bullets and load I have a hard time keep all shot on the plate. My range in under water from about 50 yards to 100 yards due to all the rain we keep getting. I try to set up a few target at one time to reduce the trips through the mud and water. I'll figure out something.

I checked my primer supply and I don't have as much variety as I once did and with empty shelves at Cabela's I'm not likely to pick up anything new soon. I hate election years! I'll test with what I have and see what works best and go with that until thing get better, if they get better! Did I mention that I hate election years?
Jim Kluskens
aka Distant Thunder
Reply


Messages In This Thread
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 09:24 AM
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 05:59 PM
RE: Development of PP loads for the .44-77. - by seahawk - 07-01-2020, 10:08 AM
RE: Development of PP loads for the .44-77. - by Distant Thunder - 07-30-2020, 11:35 PM
RE: Development of PP loads for the .44-77. - by Steveu - 07-31-2020, 11:16 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication