Historic Shooting Forums › General › Reloading › Paper Patch v
Development of PP loads for the .44-77.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Development of PP loads for the .44-77.
07-30-2020, 05:50 PM,
#222
Kurt Offline
Grand advisory committee
*****
 		Posts: 4,246
Location:
Joined: May 2012
Reputation: 2
RE: Development of PP loads for the .44-77.
Hey Jim.

I found my mould at the front door when I got home from the range. Jim really has the mould making down from the last one I got. Fine looking mould.

The sample bullet is about a thousands small in diameter but may mike has taken the deep dive on the hard floor a couple times but even I can live with that. The base and shank is .001" less but round. The ogive is a little sharper then I expected but this will tell when I starts shooting it. The radius is a little longer then I thought it would be. But I haven't measured it to make sure.
But the way it looks it should fly!! Smile
The reason a dog has so many friends is because he wags his tail instead of his tongue.
Find
Reply


Messages In This Thread
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 09:24 AM
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 05:59 PM
RE: Development of PP loads for the .44-77. - by seahawk - 07-01-2020, 10:08 AM
RE: Development of PP loads for the .44-77. - by Kurt - 07-30-2020, 05:50 PM
RE: Development of PP loads for the .44-77. - by Steveu - 07-31-2020, 11:16 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication