Development of PP loads for the .44-77.

[J.B.]

Well clearly I dont have enough runs on the board .. especially on paper... so I'll take your advice on board Jim. I'm too lazy to unwrap what I've done..so I'll take an eccentric line from one point of the template and see if I cant eliminate that overlap altogether. Never a problem with parallel sides designs but these are a little more challenging for me... and having three different diameters probably isn't helping either. I've another 35 to wrap so I'll see if I can improve on what I've done. I'm keen to see how you guys go with that BACo mould on Arnies design. I'd bring up the diameters probably two thou on the shank and one on the base if I put in an order. My experience with moulds is that most come in a hair under rather than over. I guess you can always use thicker paper.. although the option is there to size overall too with a push through die.. but that doesn't work so well on the shank in a dd design. . Thanks for the tip .. I'll see how I go.

J.B.

p.s. finally looks like I've got a rough idea of what I'm doing....rough. Trimmed the top of the patches back about .04 or so and they are looking tidier... either just meeting or only a hair between.