Historic Shooting Forums › General › Reloading › Paper Patch v
Development of PP loads for the .44-77.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Development of PP loads for the .44-77.
07-06-2020, 08:02 PM,
#147
Distant Thunder Offline
Posting Freak
*****
 		Posts: 921
Location: NE Wiscinsin
Joined: May 2017
Reputation: 0
RE: Development of PP loads for the .44-77.
The guy at BACO seemed to think they got behind spending too much time working with these 2-D PPB and not enough time cutting molds. It was just a sales guy I talked to so I'm not sure he had the details of the story correct so we'll see where it all goes. I've done a couple of favors for Dave over the years, not that he owes me anything, but he may consider that when he looks at it.

I hope so because I've been planning on them for the 2-DEPP mold all along. If for some reason they decline to do it I'll go to Rick at KAL.
Jim Kluskens
aka Distant Thunder
Find
Reply


Messages In This Thread
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 09:24 AM
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 05:59 PM
RE: Development of PP loads for the .44-77. - by seahawk - 07-01-2020, 10:08 AM
RE: Development of PP loads for the .44-77. - by Distant Thunder - 07-06-2020, 08:02 PM
RE: Development of PP loads for the .44-77. - by Steveu - 07-31-2020, 11:16 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication