Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Development of PP loads for the .44-77.
06-28-2020, 03:50 PM,
#85
RE: Development of PP loads for the .44-77.
Tested the following:

450 gr. BACO 431ADJ
.060 LDPE
78.0 grs. Goex 2f '07
Hornady brass
Federal 210 LR primers

6 inches of vertical.

Next up.

520 gr. BACO 431ADJ 1.425" long
.060 LDPE
78.0 grs. Goex 2f '07
Hornady brass
Federal 210 LR primers

   

I must have miss calculated when I came down with my scope setting because the first shot went under the target. So I came up and I guess I've got a ways to go on this scope, any scope really, the next one was at the top of the cardboard. That like 30 inches! So I shot the next one to the same place (very close to it). Since I only had 3 of each loaded I now had to decide if I just skip that load and move to the next or go back to the house and load one more and shoot it hoping it hits the target. Well, I just had to know! I loaded one more. The darn thing went in the same place! So 3 shots in 2 7/8 inch. That's the best yet.

Next up.

So I came down for the next load. Too far again, now I at the bottom of the paper! Good enough! Those 3 then went into 4 3/8 inches.

530 gr. Sharps style bullet
.060 LDPE
78.0 grs. Goex 2f '07
Hornady brass
Federal 210 LR primers

   
Jim Kluskens
aka Distant Thunder
Reply


Messages In This Thread
RE: Development of PP loads for the .44-77. - by Distant Thunder - 06-28-2020, 03:50 PM
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 09:24 AM
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 05:59 PM
RE: Development of PP loads for the .44-77. - by seahawk - 07-01-2020, 10:08 AM
RE: Development of PP loads for the .44-77. - by Steveu - 07-31-2020, 11:16 AM

Forum Jump:


Users browsing this thread: 3 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication