Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Designing the 2-diameter paper patch bullet.
01-12-2019, 09:58 PM,
RE: Designing the 2-diameter paper patch bullet.
(01-12-2019, 01:08 AM)Distant Thunder Wrote: Kurt,

I was thinking I would submit this one for that postal, but it just isn't that good. I ran the numbers and it would score at 93.6". That wouldn't be bad for 900 yards, but I would want better at 200. That would be just a hair more than a 2 MOA group at 900, not bad, but at 200 yards I'd want to be closer to 1 1/2 MOA. If you could hold 2 MOA plus a little at 900 and be centered that would be 9s and 10s which ain't bad. At 200 it looks not so good!






Still it was fun to get out and shoot. I haven't shot prone off sticks in four months and I could feel it!

You know you can enter more than once. If no one enters a couple average loads , no one will enter at all.
Reply


Messages In This Thread
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 01-04-2019, 04:29 PM
RE: Designing the 2-diameter paper patch bullet. - by Semtav - 01-12-2019, 09:58 PM
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 05-06-2019, 09:48 AM
RE: Designing the 2-diameter paper patch bullet. - by Gunlaker - 05-06-2019, 10:25 AM
RE: Designing the 2-diameter paper patch bullet. - by Steveu - 01-16-2024, 12:10 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication