Alloy Question

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Thread Modes

Alloy Question

02-19-2018, 10:36 AM,

Kurt

Grand advisory committee

Posts: 4,246
Location:
Joined: May 2012
Reputation: 2

RE: Alloy Question

John all three alloys are good for the GG bullet. The WW+2% tin is hard. I would not use for the PP unless it's patched over bore diameter.
WW cut 50/50 with lead is a good alloy that will hold the nose as well as 1/16-17 but it's very close to 1/20 in temper.

The reason a dog has so many friends is because he wags his tail instead of his tongue.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Alloy Question - by SgtDog0311 - 02-18-2018, 08:11 PM

RE: Alloy Question - by Kurt - 02-19-2018, 10:36 AM

RE: Alloy Question - by Old Jim - 02-19-2018, 01:18 PM

RE: Alloy Question - by SgtDog0311 - 02-19-2018, 01:20 PM

RE: Alloy Question - by Kurt - 02-19-2018, 02:51 PM

RE: Alloy Question - by Smokey45 - 02-20-2018, 09:24 PM

RE: Alloy Question - by SgtDog0311 - 02-20-2018, 01:35 PM

RE: Alloy Question - by Kurt - 02-21-2018, 08:04 PM

RE: Alloy Question - by Kurt - 02-21-2018, 07:45 PM

RE: Alloy Question - by Smokey45 - 02-21-2018, 08:16 PM

RE: Alloy Question - by Kurt - 02-21-2018, 08:50 PM

RE: Alloy Question - by Old Jim - 02-22-2018, 09:37 AM

RE: Alloy Question - by Lumpy Grits - 02-22-2018, 02:20 PM

RE: Alloy Question - by Steve Anderson - 02-22-2018, 10:43 AM

RE: Alloy Question - by Old Jim - 02-22-2018, 02:29 PM

RE: Alloy Question - by Lumpy Grits - 02-22-2018, 02:37 PM

RE: Alloy Question - by SgtDog0311 - 02-23-2018, 08:11 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me