|
RE: some 44-77 questions
When I loaded the LDPE wads into the cases they were tight enough that they were slightly domed. The necks are sized tight enough that I can almost but not quite push the bullet into the case, I used a seating die. The sizing bushing is still a bit of a work in progress. Its hard but not overly hard and I can keep polishing it out till I am happy with the fit of things. I feel that there is a good chance that I will have to make a separate bushing for the PP bullets but thats not a big deal.
On another note, I went to Staples and looked around, they did have some tracing paper there in 50' rolls, one was open and a corner sticking out, a piece followed me home. It miked about .0015 to .0016. I kind of felt it was on the expensive side at $14 for the 12" roll. I dont remember the brand name but it did start with an S and it was listed as 8# paper.
I think I will just go with the SC 55W or Y, since that seems to be a known entity.
Sam
|