Historic Shooting Forums › General › Reloading › Blackpowder cartridge v
smaller then bore slicks

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
smaller then bore slicks
09-02-2012, 04:07 PM,
#11
bigted
Guest
 		 
RE: smaller then bore slicks
cool man...i do have some 120 brass that are short...[older rcbs brass that is by norma ] ... so i will cut a couple down to see if they will give thicker necks to try with. also my adjustable mould is in .452 inch diameter so will need another mould when i discover what i need for a final diameter but thanks for the suggestions ... they help imensly!
Reply


Messages In This Thread
smaller then bore slicks - by bigted - 08-29-2012, 01:10 PM
RE: smaller then bore slicks - by Don McDowell - 08-29-2012, 01:25 PM
RE: smaller then bore slicks - by bigted - 08-29-2012, 02:03 PM
RE: smaller then bore slicks - by Lumpy Grits - 08-29-2012, 02:48 PM
RE: smaller then bore slicks - by Kurt - 08-31-2012, 09:51 PM
RE: smaller then bore slicks - by bigted - 08-29-2012, 10:14 PM
RE: smaller then bore slicks - by bobw - 08-29-2012, 10:52 PM
RE: smaller then bore slicks - by Don McDowell - 08-29-2012, 11:45 PM
RE: smaller then bore slicks - by rdnck - 08-31-2012, 08:52 PM
RE: smaller then bore slicks - by Lumpy Grits - 09-01-2012, 12:37 AM
RE: smaller then bore slicks - by bigted - 09-02-2012, 04:07 PM
RE: smaller then bore slicks - by bigted - 09-03-2012, 06:17 AM
RE: smaller then bore slicks - by Lumpy Grits - 09-03-2012, 12:14 PM
RE: smaller then bore slicks - by bigted - 09-06-2012, 03:49 AM
RE: smaller then bore slicks - by Lumpy Grits - 09-06-2012, 11:57 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication