Lube Migration?

[Eric Johanen]

Loaded up some 45-70 paper patched loads with the BACO 530 grain .441 patched up to .4485. Winchester brass necksized at 2.10 length. CCI LR Bench Rest Primer with 78.0 grains of OE 1.5 weighed. .060 vegie card, 1/8 inch SPG lube wad and a orange juice carton over lube wad. Compressed to .430, finger seat the bullet and light taper crimp to hold snug. I noticed some lube migration in the inside of the case above the wad stack and wiped out with q-tips. Should I be compressing the .060 card first and just drop the lube wad and over lube card into the case, place with a dowel and then seat the bullet? How do you guy's do this to avoid the lube migration. I loaded some up last fall and a few days later took them to the range and noticed lube migration up the paper patch. They did not shoot very well with the lube soaked paper patch. I'm going to work up a hunting load to shoot dirty and could use a bit of advise. (Note: this is with a Standard Shiloh Chamber).