Historic Shooting Forums › General › Reloading › Blackpowder cartridge v
smaller then bore slicks

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
smaller then bore slicks
08-29-2012, 01:25 PM,
#2
Don McDowell Offline
Administrator
*******
 		Posts: 6,735
Location: Ft. Laramie Wy
Joined: May 2012
Reputation: 2
RE: smaller then bore slicks
Ted might I suggest it will save you considerable money, yet get you quality moulds if you go thru accurate and get him to make you the slick you want in his aluminum blocks. Then you can later go with that diameter bullet in an iron block from someone if you think theres a need...
Good to see you here by the way.
Find
Reply


Messages In This Thread
smaller then bore slicks - by bigted - 08-29-2012, 01:10 PM
RE: smaller then bore slicks - by Don McDowell - 08-29-2012, 01:25 PM
RE: smaller then bore slicks - by bigted - 08-29-2012, 02:03 PM
RE: smaller then bore slicks - by Lumpy Grits - 08-29-2012, 02:48 PM
RE: smaller then bore slicks - by Kurt - 08-31-2012, 09:51 PM
RE: smaller then bore slicks - by bigted - 08-29-2012, 10:14 PM
RE: smaller then bore slicks - by bobw - 08-29-2012, 10:52 PM
RE: smaller then bore slicks - by Don McDowell - 08-29-2012, 11:45 PM
RE: smaller then bore slicks - by rdnck - 08-31-2012, 08:52 PM
RE: smaller then bore slicks - by Lumpy Grits - 09-01-2012, 12:37 AM
RE: smaller then bore slicks - by bigted - 09-02-2012, 04:07 PM
RE: smaller then bore slicks - by bigted - 09-03-2012, 06:17 AM
RE: smaller then bore slicks - by Lumpy Grits - 09-03-2012, 12:14 PM
RE: smaller then bore slicks - by bigted - 09-06-2012, 03:49 AM
RE: smaller then bore slicks - by Lumpy Grits - 09-06-2012, 11:57 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication