Accurate Mould

[Nuclearcricket]

Actually it should be drilled and taped on the left side of the action when looking at it from the rear. That should be the same action as my 45-70 and I have a williams peep sight on it. My Marlin also has the micor grove barrel and I have never shot anything except jacketed through it. Since I dont' shoot it much and have picked up a couple of bags of Rem 300gr jacketed bullets, I doubt I will ever throw any cast in it.
Kurt, I didn't know the 444 had such a small thin rim, I dont think I ever even handled any of those cases. The case lube I like is the stuff Dillon sells in the pump spray bottle, and you can get the same stuff from Frankfort Arsonel from Midway. Its lanolin in an alcohol mix. Throw you cases in a box, give them a spray and shake them around a bit and your ready to go. When I switched over to this lube, I cleaned my dies with alcohol and then lubed the inside of the die and I haven't had any problems since. You still can end up with extra lube on your cases and some dents on the shoulders and walls of straight cases but you can get that with any lube if your not careful. How do you like the brass mold? If I order another mold from Accurate I might go that route. The one I got from him I like a lot but I went with the Aluminum. There is not any doubt in my mind that his molds are second to none.
Sam