just took my own advice

[bruce moulds]

well I cast 20 bullets last night.
washed the mould with acetone, then heated it on the hotplate.
cast 3 to get started and even things out then 20 that weighed between 418.2 and 418.5 gns.
no break in required here!
if the mould has anything to nitpick, it could have the sprue cutter a little sharper.
this is easily done with fine abrasive on a piece of glass, but is probably not worth the effort.
most other brands are no better in this area.
the bullet finish is extremely smooth with absolutely no evidence of tool marks.
bullets just fall out of the mould.
if this is typical of baco, they are probably the best value for money moulds around.
keep safe,
bruce.