+- Historic Shooting Forums (http://historicshooting.com)
+-- Forum: General (http://historicshooting.com/forum-1.html)
+--- Forum: Reloading (http://historicshooting.com/forum-4.html)
+---- Forum: Blackpowder cartridge (http://historicshooting.com/forum-18.html)
+---- Thread: Finally it (/thread-73.html)
Finally it - Kurt - 05-30-2012
came
This .44-100 st Rem PP reamer project started way back in Sept 2011 after having two reamers sent to me that were for a all together different then what I had ordered I canceled the order and went to a different company and re ordered. Well it made it home yesterday
Checking the diameters the base is .0023 tighter then I ordered but I will give the reamer maker the benefit of doubt because I dropped my didgee mike on the concrete floor yesterday
Now to get the 15# 35" .44 barrel fitted to a action and make some loading dies with this reamer for this Tollofson class rifle.
Kurt
![[Image: IMG_0334.jpg]](http://i704.photobucket.com/albums/ww43/Kurtalt/IMG_0334.jpg)
RE: Finally it - Don McDowell - 05-30-2012
Will you have it ready in time for some test firing at the Quigley?
RE: Finally it - drcook - 05-30-2012
Kurt,
does you mic still have the mechanical markings or is strictly digital. if you screw it all the way in, tighten it up on a piece of paper and pull the paper out (which cleans the anvils) and then close it, it should read 0.
you can also double check it on the shank end of the reamer. I will bet that reamer shank is 7/16 which should measure .4375. that will check you mics out. then also check the bore pilot against the size you specified. that should be good enough to tell if your mics are reading true.
do you have a 1/2 dowel pin. a real one, not a wood dowel. a 1/2" dowel will measure .500 of course and will be close enough to check you mics at that spot also.
dave
RE: Finally it - Kurt - 05-30-2012
Don.
Don't I wish!!!!!!
RE: Finally it - Don McDowell - 05-30-2012
Well just spin the barrel off of something , chuck that bad boy biggun in your lathe, and let's geter done...
RE: Finally it - Kurt - 05-30-2012
Don.
If my lathe was running I would.
I sheared a 1/2 moon key on the lead screw and made a mess out of the shaft.
RE: Finally it - Kurt - 05-30-2012
(05-30-2012, 03:28 PM)drcook Wrote: Kurt,
do you have a 1/2 dowel pin. a real one, not a wood dowel. a 1/2" dowel will measure .500 of course and will be close enough to check you mics at that spot also.
dave
I have all sorts of wood dowels. I can get all sorts of readings I want and need on the mike with them 
RE: Finally it - Don McDowell - 05-30-2012
Oh My that doesn't sound good at all...
RE: Finally it - Kurt - 05-30-2012
Yes it will Don.
I can make anything work. LOL