Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
C. Sharps High Wall single set trigger problems
12-26-2018, 05:28 PM
Post: #1
C. Sharps High Wall single set trigger problems
When I drop the lever and open the action, the hammer goes to full cock, then I close the action, push the set trigger forward and it gets set, then I pull the trigger and it just clicks, hammer does not fall. I’ve adjusted the set trigger both ways all the way and it just does the same thing. Is my sear broke?
Find all posts by this user
Quote this message in a reply
12-26-2018, 08:18 PM
Post: #2
RE: C. Sharps High Wall single set trigger problems
Probably best to call Pat and tell him what's going on.

A wise man can always be found alone. A weak man can always be found in a crowd.
Find all posts by this user
Quote this message in a reply
12-26-2018, 08:19 PM
Post: #3
RE: C. Sharps High Wall single set trigger problems
Will it fire in single trigger?

A wise man can always be found alone. A weak man can always be found in a crowd.
Find all posts by this user
Quote this message in a reply
12-26-2018, 08:54 PM
Post: #4
RE: C. Sharps High Wall single set trigger problems
(12-26-2018 08:19 PM)Don McDowell Wrote:  Will it fire in single trigger?

Yes
Find all posts by this user
Quote this message in a reply
12-26-2018, 08:57 PM
Post: #5
RE: C. Sharps High Wall single set trigger problems
Probably best to call Pat in the morning and tell him what's going on. Sounds like the a spring problem or something hanging the fly up.

A wise man can always be found alone. A weak man can always be found in a crowd.
Find all posts by this user
Quote this message in a reply
12-27-2018, 11:39 AM
Post: #6
RE: C. Sharps High Wall single set trigger problems
Please keep us updated, and good luck on a easy fix.
Gary

Hav'n you along, is like losing two good men.....
Find all posts by this user
Quote this message in a reply
12-27-2018, 07:11 PM
Post: #7
RE: C. Sharps High Wall single set trigger problems
(12-27-2018 11:39 AM)Lumpy Grits Wrote:  Please keep us updated, and good luck on a easy fix.
Gary

Tang site screw just below the hammer was screwed in too far and was hitting the spring.
I just got this rifle. Bought it used. The guy said he only fired it a few times. Said his eyesight was to poor to see through the sights so he sold it. It looks brand new. I had C. Sharps run the serial number. Made in 1999. It has a #4 Badger 30” barrel. 45-70. Can’t wait to shoot it.
Find all posts by this user
Quote this message in a reply
12-27-2018, 08:45 PM
Post: #8
RE: C. Sharps High Wall single set trigger problems
Good to hear it was a fairly simple fix.

A wise man can always be found alone. A weak man can always be found in a crowd.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)