Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
First attempt at semi inletted grips
06-02-2018, 08:45 PM
Post: #1
First attempt at semi inletted grips
I still have a little finishing left to do but here are some American Holly grips on my Ruger .480 Bisley

[Image: D62015C4-9331-4DC3-B8DA-F6A52E461046.jpg]


[Image: EABA3B6B-4BDF-423E-AE86-9C0AA331C0A8.jpg]
Find all posts by this user
Quote this message in a reply
06-02-2018, 09:58 PM
Post: #2
RE: First attempt at semi inletted grips
Niiiiiice ExclamationBig Grin Bet that makes a statement when the cap goes off Tongue I had some antique 'tru ivory' Barrs grips on a pair of blued USFA single actions a few years back. They certainly looked the part. Looking good Pacecars Smile

" Don't know where I'm going but there's no sense being late " !
Find all posts by this user
Quote this message in a reply
06-02-2018, 10:09 PM
Post: #3
RE: First attempt at semi inletted grips
Thanks. The factory grips fi like crap and I tried some plastic Ivory looking grips that cracked after a few shots. I like the way Holly mimics the looks of Ivory and ages like it too. Recoil is not too with the loads I am shooting. I am loading a hard cast 400 gr bullet from a Lee mold at 900 - 1000 FPS. It goes through deer and hogs and takes bones with it. Haven't recovered one yet from any angle.
Find all posts by this user
Quote this message in a reply
06-03-2018, 07:52 PM
Post: #4
RE: First attempt at semi inletted grips
Nicely done! They look great.

I like the Bisley too.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)